MiniControl

extension module for SOK and multiplier of measurement channels

Product description:

Optional, additional module for the cathode protection monitoring set for programming the MiniTrans and MiniTransPlus sensor and doubling the measurement channels.

Control of the cathode protection station

If the MT or MTP receives a command to control the cathode protection station, it transmits it to the MiniControl module (“0” or “1”) by means of a special combination of calls. The corresponding relay output “LA+” and “LA-” will be closed for 200 ms. The adapted control of the cathode protection station responds to the closure of the relay clutch, and regulates the output voltage accordingly: higher relative to lower.

Double Channel

Duplicate channel outputs (K1MT, K2MT, MIKMT, GNDMT) should be connected to MT/MTP input channels. Galvanically separated sides of the channel (K1A, K2A, MIKA, GNDA) respectively (K2B, K1B, MIKB, GNDB) should be connected with two measurement points. Outputs for channel pages can be separated (TaktA and TaktB) or used together (TaktMT).


The dual channel is controlled by MT/MTP using a combination of MiniControl modules (“2” or “3”). Measurement of both sides of the channel takes place at intervals of 5 minutes according to the measurement times. With the help of the WinTrans software, the doubled channels will be independently assigned to the appropriate measurement locations.

Question about MiniControl - extension module for SOK and multiplier of measurement channels

For documentation, please fill in the form or contact us.

EN: Question about MiniControl - extension module for SOK and multiplier of measurement channels